hss turning tools, hss turning tools suppliers and ...

hss turning tools, hss turning tools Suppliers and ...

1,303 hss turning tools products are offered for sale by suppliers on Alibaba.com, of which turning tool accounts for 27%, milling cutter accounts for 2%, and tool holder accounts for 1%. A wide variety of hss turning tools options are available to you, such as external turning tool, internal turning tool, and thread turning tool.

Ask For Price
beginner's shopping list for turning tools and sharpening ...

Beginner's Shopping List for Turning Tools and Sharpening ...

Traditionally, turning tools were made of carbon steel, and it is not uncommon to find these tools in garage sales, auctions, and as giveaways with used lathes. Turning tools sold today are almost all HSS, which is tougher than carbon steel and holds an edge longer.

Ask For Price
hss lathe tool, hss lathe tool suppliers and manufacturers ...

hss lathe tool, hss lathe tool Suppliers and Manufacturers ...

325 hss lathe tool products are offered for sale by suppliers on Alibaba.com, of which turning tool accounts for 50%, milling cutter accounts for 5%, and knife accounts for 1%. A wide variety of hss lathe tool options are available to you, such as external turning tool, internal turning tool, and thread turning tool.

Ask For Price
hss or carbide inserts fot lathe turning???? | the hobby ...

HSS or Carbide inserts fot lathe turning???? | The Hobby ...

Just another data point. I have a little 7x14 and use both the HSS and the set of carbide tools from LMS. The angles on HSS tools are *kinda* important to get perfect results but pretty forgiving to make a good enough finish. A few degrees doesn't make that much difference. The biggest things to make for a nice finish is the honing after grinding and the radius of the cutter. A grinder leaves a pretty rough finish on the tool.

Ask For Price
turning inserts - turning tools | misumi

Turning Inserts - Turning Tools | MISUMI

Turning Insert Diamond 80°, Negative. Negative Tip for T-Max P Turning Tool. Turning Insert Diamond, with Hole, 55°, Negative, DNMG15 -TSF "for Finishing" Turning Insert Diamond, with Hole, 80°, Negative, CNMG12040 R/L-S "for Intermediate Cutting" Triangle with Hole, 60° Negative TNMG220408-

Ask For Price
poor surface finish when turning. (manual lathe)

Poor surface finish when turning. (manual lathe)

Poor surface finish when turning. (manual lathe) ... Insert Material: Carbide and HSS (both are producing the same bad finish) ... Using my turning tool with a Kennametal insert on my QCTP, I cranked up the RPM to 910 and increased my DOC to .025" at a feed rate of .0035" per rev. The picture tells the story.

Ask For Price